Rikudou_Sage to [email protected]English • 10 months ago3D printed Portal coastersi.imgur.commessage-square14fedilinkarrow-up1294file-textcross-posted to: [email protected][email protected][email protected]
arrow-up1289image3D printed Portal coastersi.imgur.comRikudou_Sage to [email protected]English • 10 months agomessage-square14fedilinkfile-textcross-posted to: [email protected][email protected][email protected]
minus-squareJackGreenEarthlinkfedilinkEnglish4•10 months agoIs this a dual filament printer, or simply gaps in the material?
minus-squareRikudou_SageOPlinkfedilinkEnglish6•10 months agoWhat @[email protected] said, I changed the filament in the middle of the print using the M600 command.
minus-square@[email protected]linkfedilinkEnglish6•10 months agoThere is also a technique where you manually swap out the filament at a certain layer height. Based on the shared STL files I think that’s the case here.
Is this a dual filament printer, or simply gaps in the material?
What @[email protected] said, I changed the filament in the middle of the print using the M600 command.
There is also a technique where you manually swap out the filament at a certain layer height. Based on the shared STL files I think that’s the case here.