@[email protected] to [email protected] • 1 year agoJust upgraded, does anyone have pointers for when I unbox/setup?lemmy.worldmessage-square12fedilinkarrow-up127file-text
arrow-up125imageJust upgraded, does anyone have pointers for when I unbox/setup?lemmy.world@[email protected] to [email protected] • 1 year agomessage-square12fedilinkfile-text
I know it’s only a 6” but that’s all I need right now, couldn’t justify the extra expense for the 8” at the moment.
minus-square@[email protected]linkfedilink4•1 year agoCheck the calibration: Confirm that the outfeed table is parallel to the cutter head. Confirm that the outfeed table is level with the top dead center of the cut. Then confirm that the infeed table is parallel to the outfeed Lastly confirm that the fence, when set to 90, is square to the outfeed table. This should all the the case right out off the pallet but it’s worth a check.
minus-square@[email protected]linkfedilink4•1 year agoAdding on to this calibration comment that an engineer square is much more accurate for setting up machines than a carpenters square (which are often knocked out of alignment).
minus-squareUgly Boblinkfedilink1•1 year agohttps://www.youtube.com/watch?v=Hg53x5W7YOc The wood and plastic squares are super easy to adjust.
Check the calibration:
This should all the the case right out off the pallet but it’s worth a check.
Adding on to this calibration comment that an engineer square is much more accurate for setting up machines than a carpenters square (which are often knocked out of alignment).
https://www.youtube.com/watch?v=Hg53x5W7YOc
The wood and plastic squares are super easy to adjust.