@[email protected] to [email protected]English • 11 months agoMy CR-10's had a good run but I made a slight upgrade todaylemmy.worldmessage-square14fedilinkarrow-up186
arrow-up183imageMy CR-10's had a good run but I made a slight upgrade todaylemmy.world@[email protected] to [email protected]English • 11 months agomessage-square14fedilink
minus-square@jaschenlinkEnglish3•11 months agoI guess bamboo does not have exclusive to lidar printing now. It’s significantly cheaper than bamboo. My MakerBot x2 has an enclosure but it only prints ABS. But leveling prints is so annoying. Too bad I have to make a trip out there to buy it haha. Thanks for the info.
I guess bamboo does not have exclusive to lidar printing now. It’s significantly cheaper than bamboo.
My MakerBot x2 has an enclosure but it only prints ABS. But leveling prints is so annoying.
Too bad I have to make a trip out there to buy it haha. Thanks for the info.