I dont know why they have to lie about it. At $5/8ft board you’d think I paid for the full 1.5. Edit: I mixed up nominal with actual.

  • @[email protected]
    link
    fedilink
    English
    1437 months ago

    Is nobody gonna call out OP for wearing socks with sandals? …and, ostensibly, while preparing to do carpentry?!?

    That’s like a cardinal sin squared!

    • @[email protected]
      link
      fedilink
      English
      207 months ago

      Nah nothing wrong with wearing socks with sandals when you’re home. Do what ever the hell you want.

      But I do agree with wearing proper footwear while doing dangerous things.

      • fatboy93
        link
        fedilink
        English
        107 months ago

        Oh absolutely. I wear socks with sandals because my soles sweat and make my sandals sticky.

        But yeah, wear proper attire for the work you do!

    • @[email protected]
      link
      fedilink
      English
      157 months ago

      Can’t you see those are safety sandals. And just like safety squints, are approved PPE across the whole 3rd world industrial sphere. OP will be perfectly safe.

      • @[email protected]
        link
        fedilink
        English
        107 months ago

        For a machinist yep. For home gamers, a waste of money. They don’t have the knowledge of where and when to use them nor the skills to get accurate repeatable measurements. So for OP’s use whatever CCC, (Cheap, Cheerful, Chinese), caliper he’s got is good enough.

        It’s the definition of “nominal size is what ever we say it is” that pisses me off. Buying wood/lumber is the worst offender of Nominal sizing, but even metals are getting worse. I used to buy a round bar of say, ASA1018 and it would be +0"/-.002". It’s now +0/-.006", (that’s +0/-.05mm and +0/-.15mm for those living in Boca Raton). At the end of my career as a toolmaker I was often forced to purchase oversized stock and waste time turning said stock into the actual sizes required.

      • @[email protected]
        link
        fedilink
        English
        9
        edit-2
        7 months ago

        My toolbag calipers are cheap hardware store ones. They’re accurate enough and I’m not out much when they inevitably get damaged or lost.

      • @[email protected]
        link
        fedilink
        English
        37 months ago

        I can accept the poor quality tools that might be off by a few hundredths, but using imperial on precision measurement devices is unforgivable.

    • @[email protected]
      link
      fedilink
      English
      6
      edit-2
      7 months ago

      I regularly wear socks and sandals along with shorts and a sweater.

      There was also a time I went to lunch with that plus a lab coat and hairnet.

    • Dizzy Devil Ducky
      link
      fedilink
      English
      37 months ago

      I don’t condone it, but I’ve done something similar once in a Boy Scouts meeting as a scout. Had sandals on and I don’t remember the full meeting, but at one point we were chopping wood with an axe. I did it, but that’s not my brightest move. There was also a time where I was getting my metalworking badge and entered the forge one time for a kinda free time work on your project thing with shorts on by mistake. Nobody stopped me in either case. This wasn’t pre-2000s, so I’m not sure how I got away with either event considering safety is usually taken much more seriously nowadays.

    • @[email protected]
      link
      fedilink
      English
      37 months ago

      My COVID home-improvement project was hardwoods. Something like 1000sqft. Never did it before. Did 90% of it wearing no more than basketball shorts and flipflops. W/e. Only a few toe injuries.