• @[email protected]
    link
    fedilink
    English
    316 months ago

    This works great if everything is fresh and new, now post a guide about cleaning up/redoing 20 year old solder without burning a hole in the board 😅

    That solder wick stuff makes me want to rage

    • @[email protected]
      link
      fedilink
      English
      18
      edit-2
      6 months ago

      Clean everything with a board cleaner/alcohol.

      Use a heat gun for the stubborn things.

      Solder wick is fine, but if it’s a through hole on a ground plane your going to be there a really long time.

      Use the least amount of heat you can get away with.

      Sometimes adding fresh solder on top of the old solder helps the heat spread so you can use the wick more effectively.

      Constantly use fresh wick, and if it’s really stubborn dip your wick in extra flux.

      Desoldering guns are awesome, but a little spendy.

      • @[email protected]
        link
        fedilink
        English
        76 months ago

        Massive Ground planes on a multi layer board were my breaking point.

        I tried to clean the through holes where a micro USB port was secured and only could get it cleared by drilling out the solder… (Only had a soldering iron and wick available)

      • Kogasa
        link
        fedilink
        English
        46 months ago

        Adding fresh solder can also help if it’s leaded / flux cored and the existing solder isn’t

      • @[email protected]
        link
        fedilink
        English
        26 months ago

        I’ve done the rgb mod for an old NES. The PPU is on a big ground plane and just impossible to get off using a wick. Or you can, but now you’ve put so much heat into the chip that you fried it. Need a heat gun or hot plate.

        Playstation SD card mod is easier than hand desoldering the NES PPU, and it involves scraping away very thin traces and soldering to them.

    • capnminus
      link
      fedilink
      English
      106 months ago

      Add generous amount of flux and fresh solder to it