I’ve searched around and mostly seen people create custom radiator builds attached to their water supply, but that’s beyond my skill level and I’m not sure if linking it directly to the water supply via piping would violate the lease or not. Are there any solutions a bit more DIY that I could take advantage of?

  • @[email protected]
    17•4 months ago
    1. Find a pair of vehicle radiators that are as close to a box fan in size as possible.
    2. Zip tie them to either side of the box fan. As the fan blows: it will draw air in through the “second radiator” and blow it out through the “first radiator”.
    3. Hook the out of the first radiator to the in of the second using flexible hoses. Cheap garden hoses might even fit.
    4. Hook other hoses to the in of the first radiator and the out of the second.
    5. Run water on through the first radiator, out of the second. This makes the most efficient heat transfer possible.
    • @[email protected]
      12•4 months ago

      This is exactly what I was going to suggest. Use the water to cool the radiators, and use fans to push hot air through the cool radiators, cooling the air in the process.

      This is basically what AC does on a much larger scale. It uses refrigerants, a compressor, and some basic physics to cool the radiators, but it’s still the same basic concept.

    • @[email protected]
      1•4 months ago

      I don’t think a box fan could cool one entire 20x20in automotive radiator, let alone two.

      fan -> plenum -> radiator would probably work best. The plenum only needs to be a few inches long, it’s just to direct the entire square of the fan over the entire square of the radiator. Cardboard and caulk would work.

      It’s a low efficiency heat exchanger.