The Los Angeles Police Department has warned residents to be wary of thieves using technology to break into homes undetected. High-tech burglars have apparently knocked out their victims’ wireless cameras and alarms in the Los Angeles Wilshire-area neighborhoods before getting away with swag bags full of valuables. An LAPD social media post highlights the Wi-Fi jammer-supported burglaries and provides a helpful checklist of precautions residents can take.
Criminals can easily find the hardware for Wi-Fi jamming online. It can also be cheap, with prices starting from $40. However, jammers are illegal to use in the U.S.
We have previously reported on Wi-Fi jammer-assisted burglaries in Edina, Minnesota. Criminals deployed Wi-Fi jammer(s) to ensure homeowners weren’t alerted of intrusions and that incriminating video evidence wasn’t available to investigators.
Even beyond renting, installing a wifi camera is SO much cheaper than running Ethernet all over your house. And if you need it run through an external wall? Even more money.
Not if you DIY. I just finished a project, not only wiring all rooms for Ethernet, but PoE for 10 exterior cameras.
You can get 500ft Cat 5e boxes off eBay for like ~$20, an extra long 1/2 inch drill bit (for punching through the exterior wall) was like another 20. Most expensive part was probably the metal conduit for the outside runs (I decided to only have 2 or 3 holes to the outside and run the cables in the conduit along the soffit to converge to one of 3 exterior holes for final routing within the house. That was probably 150-250)
All in all after estimating for secondary costs, like screws, brackets, sealant, a caulk gun, ceiling bracket for ceiling routing indoors etc this project was probably <400, pretty cheap as far as home improvement projects go
You can save on all that conduit with direct burial Ethernet.
Do you really need either when you’re running the cable down the soffit where it’ll never really get exposed to sun or rain?
No - I use some standard stuff in areas like that, when I’m able to come right out and under the soffit or siding. If I have to make a run, closer to the ground, with a brick facade, I’ll use it. I won’t go crazy actually trying to burry it when it stays near my house hidden by shrubs.
I have buried it for customers that require connections located in dislocated structures - trenches and filling by others though. 😅
Good because I didn’t use either and also tucked mine up in the soffit albeit with some short runs before they go into the attic. It is not something I’d like to revisit 😆
Not that expensive to do it yourself. Getting a fish tape and a cheaper Ethernet termination kit would set you back at most $50. Only other tools you need is a drill and most homeowners should already have that. And a really long bit is cheap at harbour freight.
Yup, cost isn’t the issue, time and patience are. In order to run cables down my walls, I’d need to wade through 2-3 feet of insulation fluff in my attic while stepping only on roof cross-beams, all with only like 7 feet of space at the center (way less at the edges). The cable and tools will only cost $100-200, but the whole process is a giant pain to actually do.
A bit of plastic trunking, an ethernet cable, and a long masonry bit for your hammer drill to get through the brick wall, oh and a little sealant, not that expensive, I believe in you!
I’m gonna fall through the ceiling :(
That’s not cute, it’s tragic