I did an oil change. Thought the car took 4.4 quarts but it only takes 3.7 quarts. I poured in slightly under 4 quarts. The engine is a 1.5 in-line turbo (Honda Civic Si). It’s reading past the fill line slightly. How bad is it? Do I need to pour some out? What am I risking? What symptoms should I be looking for?

    • @[email protected]
      link
      fedilink
      25
      edit-2
      5 months ago

      Close enough!

      Edit for a recommendation to OP: if you plan to change the oil in the same car for the foreseeable future – get a transparent plastic pitcher and add a fill line mark for the oil on the outside with nail polish, in your case 3.7 quarts. I do this with my car and makes for a no brainier oil change.

      • @aubeynarf
        link
        85 months ago

        If you also do this for the container you drain old oil into, you will be able to see if your car is starting to shown signs of oil consumption issues.

        E.g. if you know you fill with 3.7qt, and you drain less than 3.7qt, you know you need to start checking the oil level every few fillups.

        • @OneStepAhead
          link
          English
          75 months ago

          Generally a great idea. On this particular motor you’re more likely to find EXTRA volume as it has a known issue of gasoline flowing past the rings and actually increasing the volume of liquid in the crankcase.

  • @[email protected]
    link
    fedilink
    English
    42
    edit-2
    5 months ago

    Automechanic for 10 years here.

    No. A little over the max fill line on the dipstick isnt going to hurt it. 1/8 of an inch overfilled or less is okay.

    Usually if you don’t prefill the oil filter and only add what they say then sometimes it can be a little under. Its not a big deal.

    Way too much and you risk damaging piston rings or flooding, but you really have to fill it to the point its spilling from the dipstick tube.

    • @[email protected]
      link
      fedilink
      65 months ago

      Having once upon a time overfilled my oil by almost a quart, I think you are mostly right.

      Engine oil should stay in the crankcase. During normal operation, some of it is pumped elsewhere to lubricate the crankshaft, cams, and other mechanical components. The rest of the oil sloshes and splashes around the crankcase keeping everything slippery. If there is too much excess in the crankcase, components moving can push the oil somewhere it shouldn’t be.

      In my case, when turning left, the excess oil was pushed passed the piston rings and burned in a huge cloud of blue smoke. It wasn’t a proud moment, but stopping in a random service station and having Bruce try to drain a quart of oil out of the engine, because I couldn’t afford a full oil change was awkward.

      … Anyway: all of that to say this:

      If you have too little, your oil pressure light will probably come on. If you have too much, you’ll notice it somewhere else.

      • @[email protected]
        link
        fedilink
        English
        3
        edit-2
        5 months ago

        If you find yourself overfilling often, or if you are in the business and do heavy line work like I did (engine/transmission replacements and overhauls), just save yourself the time and get a fluid evacuator. If you overfill something you can pump a bit back out, they make them with pneumatic attachments or with a handpump that looks a bit like a bicycle tire air pump. Shove the little feed tube down the dipstick and pump whatever you need to back out.

        EDIT: Fluid Evacuator

    • @[email protected]
      link
      fedilink
      5
      edit-2
      5 months ago

      My wife was a mechanic (lube tech) for a year or two when we were first dating. One guy came in after TOPPING OFF his oil with WATER and was complaining that it wasn’t running right

      • @[email protected]
        link
        fedilink
        English
        35 months ago

        Its pretty unusual to have lube techs doing any diagnosis, but did she ask him if he likes chocolate milkshakes? Because That’s exactly what you create when you mix water in engine oil. Just don’t drink it.

      • @[email protected]
        link
        fedilink
        English
        125 months ago

        I mean, you don’t HAVE to. But you can pour some oil into the filter to pre-fill it so the oil doesn’t have to pump so long for the air you cycle out of the system, but the amount of time that happens for is so small it basically doesn’t matter. If the oil filter is easy to access and faces upward (the solid part faces the floor and open part faces up) then I would do it, but I wouldn’t do it in any other circumstance just to not have oil spilling and making a mess everywhere.

        Youre not going to blow up the engine if you don’t. But it gives some people better peace of mind.

      • yeehaw
        link
        fedilink
        1
        edit-2
        5 months ago

        I just don’t pil change, it might show a little high, then you run the motor to cycle it through the system then it levels out. Good enough. A little less or extra doesn’t hurt anything.

        Source: not a mechanic, but I know a lot of them and I’ve never taken my personal vehicle in for a change in 25 years.

  • @[email protected]
    link
    fedilink
    125 months ago

    If you had got it changed by a professional, they would have simply poured in all four quarts. You didn’t hurt a thing.

  • @[email protected]
    link
    fedilink
    9
    edit-2
    5 months ago

    When it’s still somewhat reasonable “too much”, as opposed to flooding the entire engine block with oil, the worst case scenario is that the piston rings get damaged, resulting in small amounts of oil making its way into the combustion chamber and gets burned off. Long term effects of this is that the engine consumes a little bit of oil.

    In your case, I think you’ll be fine. It’s so little over, that I wouldn’t worry about it. You might see the engine burn off some oil and eventually stabilize on a more healthy level. Check the dip stick or whatever it’s called in English regularly, and see if it decreases (slowly) to the correct level.
    Not decreasing: It’s fine
    Decreasing and stabilizing: Best case scenario
    Decreasing and doesn’t stabilize (not likely): Damaged piston rings. Slightly reduced engine performance, and your car has an mpg for oil now. Otherwise it’s fine. It’s worth noting that damaged piston rings is common in old cars, and it may have been like this from before.

    Source: I am no expert, so take what I say with a bucket of salt. I did experience the last scenario myself about 15 years ago. I still drive it with no long term effects.

    🚗

    • Irremarkable
      link
      fedilink
      5
      edit-2
      5 months ago

      Had an old accord that started burning oil at about 100k miles. Lasted another 100k with only a handful of oil changes (I think none in it’s last 50k, just topping it off as needed). Still worked perfectly fine besides very slowly burning oil when I totaled it at 200k miles.

      I miss that car. I’m convinced I could’ve gotten at least 300k miles out of it.

      • @aubeynarf
        link
        45 months ago

        This kind of neglect of proper maintenance is why it started burning oil at 100k.

        If you want your engine to last, you change the oil every 5000 to 7500 miles.

        • @OneStepAhead
          link
          English
          55 months ago

          Lol. Old Honda engines are known for essentially not needing oil. I have a B18 that refuses to die. It’s leaked so much oil before that I got barely a quart and a half out once. I try to top it up every once in a while but with 267k and just about everything else falling on the car, I’m about to stop bothering with oil on it all together so I can justify a new (to me) car.

          • @[email protected]
            link
            fedilink
            35 months ago

            My old jeep with the 4.0 was like that. I just kept adding oil every week or two when it got down past the safe zone, not doing any oil changes for about 60k. That thing had about 260k on it when the transmission blew up and I didn’t have the time or money to keep going with it. My 2010 is damn near the same at 180k (the pos 3.8), but that motor is due to be swapped soon due to loss of compression.

        • bluGill
          link
          fedilink
          25 months ago

          Read the manual. Changing the oil too soon is not helpful. modern oils often give the least wear at 8000 miles (the longest chain moleculs break down and that is accounted for by making the longer than needed.

          if you really want the engine to last install a bypass filter use 25k mile oil and then do an oil analisys every 10k miles when you replace the filters - only changa oil when the lab says so. the lab will charge more than the cost of an oil change which is why almost nobody does this.

          for most of us the engine will out last the gest of the car with just regular oil changes so this above is not useful advice.

        • Irremarkable
          link
          fedilink
          15 months ago

          We did routine oil changes between 5-6k miles until it started burning oil. I assure you, that was not the issue. We spent a while trying to figure it out before saying fuck it because it never gave us issues.

      • @[email protected]
        link
        fedilink
        English
        25 months ago

        I totaled it at 200k miles.

        I hope the shopping cart that dinged your bumper was okay…

        • Irremarkable
          link
          fedilink
          25 months ago

          Oh trust me, if It was drivable, I would’ve kept it.

          Unfortunately a younger, much more sleep deprived me flipped it one morning.

          Loved that damn car

  • oleorun
    link
    fedilink
    English
    85 months ago

    You’re good. Being a smaller engine though, I wouldn’t go much past that.

  • @[email protected]
    link
    fedilink
    75 months ago

    At least you didn’t grab a case of oil because it was on sale for $10 for 12 quarts only to realize that instead of grabbing 10w 35, I had grabbed 20w 50. Took 16 oil changes to use all that oil.

  • bluGill
    link
    fedilink
    65 months ago

    The danger is the crankshaft will hit the oil and foam up. Start the engine run at some rpm for a minute then check for foam at the dipstick if okay do a test drive with sharp corners and check again - if no foam you are okay. If ther is foam drain some out and then let the engine / foam settle overnight before driving.

    • @[email protected]
      link
      fedilink
      25 months ago

      This is the way.

      (I’ll just note that oil with bubbles in it does not look like an actual milkshake. If it looks like a milkshake, then bad things are happening.)

  • Nougat
    link
    fedilink
    65 months ago

    I wouldn’t worry about it. Even on brand new cars, there are plenty where losing (burning) a quart of oil between changes is “within specifications.” The engine is likely going to burn a little bit of oil just because, and you’ll be lower again soon enough.

  • @[email protected]
    link
    fedilink
    English
    55 months ago

    I wouldn’t think it would be a problem. If you’re concerned you can siphon some out through the dipstick opening.

  • GladiusB
    link
    fedilink
    35 months ago

    You will be ok. Over filling will not do anything other than make seals break easier. Oil circulates throughout the block all the time. A tiny bit more or short will not effect any long term performance.

    I have worked on cars my whole life and I am a logistics manager for a fleet of commercial vehicles.

  • Chainweasel
    link
    fedilink
    English
    35 months ago

    Some of that oil will be used to fill the filter so you’re fine.

  • Maeve
    link
    fedilink
    25 months ago

    It’s better to run s little too little, (neither is great)I doubt that much extra one time matters, but Ianam. A lot too much will kill it.