I’m moving into a new apt and the ISP is trying to rent a router at $20/mo, so I’d like to get my own router.
I’m considering setting up opnsense for the router & TP link Omega for the AP & Switch.
But this feels a bit overkill for an apt. Should I just get a all in one router instead? What are the pros and cons?
Something that hasn’t been mentioned yet is that open wrt works on cheap devices (check compatibility first) including in all in one router / ap combos. For home use, the most likely used feature will be cake qos which will make a difference even without crazy speeds. Though anything that gives security updates is an upgrade from generic consumer routers
I think this solution makes the most sense for my situation right now. I know it’s subjective, but do you have recommendations for 2 gigabit Internet?
For 2 gig internet you will likely need something more powerful, especially if you plan on doing much with your router (like using cake qos). The other challenge is finding a network card that works with 2.5 gb Ethernet. It is relatively easy to find a network card that works at 1G or 10G, but the 2.5G Ethernet cards tend to have issues (I have not personally had issues but forums are full of people having issues with the intel nic cards, even though intel networking cards tend to be recommended generally).
What I ended up getting ( don’t have 2.5G internet speeds, just wanted to mess around with it) was a n100 mini pc from Aliexpress. Serve the home has pretty good recommendations for hardware, and I followed their advice. They also had recommendations for switches that support 2.5G.
Here are the links:
https://www.servethehome.com/fanless-intel-n100-firewall-and-virtualization-appliance-review/
As a note, upgrading openwrt on a x86 systems such as a n100 mini pc can be annoying (but doable) especially when upgrading between major versions.
Also I highly recommend posting questions on the openwrt forums as the users there are super helpful, including to users asking questions about what hardware setups are good. It may be a good idea just to get some more perspectives/opinions. Link: https://forum.openwrt.org/
Removed by mod
Note that even if you start with an integrated wifi/router you can always by a stand-alone replacement for one function and continue to use the original unit for the other. For instance, I use my ISP supplied wifi router as a router and turn off its wifi, then use mesh wifi for whole house coverage.
Pros:
- You get your hands dirty
- You learn a lot
- You have total control of everything
Cons:
- It takes a lot of time to do anything the first time
- You’re always going to be tweaking something
- Things are going to break at random times when it’s inconvenient
No matter what you do, have an extra cheap open WRT router you can throw in when something breaks.
I for one like unifi, I would recommend their dedicated router product rather than an all-in-one device. You can always run there management software in a docker container when you need it
Well said. I run a mikrotik router for my main network and use unifi APs throughout my house. Took a lot of tinkering to set up and I learned a lot. Very flexible but more expensive and much harder to learn than a simple all in one setup.
Both options will work fine, it’s a matter of want not need. Personally I liked having a separate AP in my 1 bedroom appartment, because I could hang it on the ceiling at the center of the appartment and make sure I had good coverage vs a combo router at one corner of the appartment that barely reaches the other end properly because the ISP comes in there. Seperate AP means you can put the AP anywhere which might not be anywhere close to where the ISP comes in or where you have the router for your wired devices.
So ISP comes in in the living room, goes into my router which serves my desktop, TV and consoles wired directly there and one longer ethernet run to the middle of the hallway so I get good WiFi coverage up to the kitchen and patio.