Sure thing, chief. You were there when I bought the 1st one, there when I returned it for another one, and then held my hand through the tough times with the 2nd one. I salute you.
That was MY experience. You, as a 3d printer repair shop owner, had / have a different one. When a shop takes one back for a blatant defective part, do they send it to you? When that non-glass filled, poorly casted brass geared extruder breaks and it’s an easy-enough $15ish dollar swap, does it cone to you? Or do the majority of people just try it and it works long enough for them to think, “well maybe if I just throw a little more time and money into it, it’ll be good enough”? I. Me. The guy who’s responding. Had multiple bad experiences with Creality printers. I’m done with them. My Bambu has been great since I’ve bought it, no maintenance aside from cleaning the carbon rods and the stray strands that make their way under the build plate. I repeatedly said, that was MY experience. I won’t recommend them to anyone until I see major changes in their hardware. Feel free to disagree, but you’re trying to argue with me regarding what I dealt with for far too long before I bought a printer that… wait for it… just works.
Sure thing, chief. You were there when I bought the 1st one, there when I returned it for another one, and then held my hand through the tough times with the 2nd one. I salute you.
That was MY experience. You, as a 3d printer repair shop owner, had / have a different one. When a shop takes one back for a blatant defective part, do they send it to you? When that non-glass filled, poorly casted brass geared extruder breaks and it’s an easy-enough $15ish dollar swap, does it cone to you? Or do the majority of people just try it and it works long enough for them to think, “well maybe if I just throw a little more time and money into it, it’ll be good enough”? I. Me. The guy who’s responding. Had multiple bad experiences with Creality printers. I’m done with them. My Bambu has been great since I’ve bought it, no maintenance aside from cleaning the carbon rods and the stray strands that make their way under the build plate. I repeatedly said, that was MY experience. I won’t recommend them to anyone until I see major changes in their hardware. Feel free to disagree, but you’re trying to argue with me regarding what I dealt with for far too long before I bought a printer that… wait for it… just works.